utility razor case
Description
Want to carry some spare blades with you, but don't want to lug around the entire box? Or maybe you want to have a hook blade, and a standard blade on the go at the same time This case can hold 7 blades, and has an indent and ridge to prevent them from falling out the side if your print warps slightly The tolerances are fairly forgiving as well, and should work decently even if your printer isn't tuned perfectly (if a printer from 2015 can print it yours probably can too) The hinges are held together with regular 1.75mm filament melted at either end, however the holes will likely need to be heat formed to the right diameter (this was done to add a nice amount of friction to keep the lid from flopping around and definitely not because I didn't want to fiddle with a part that works well enough) The case is quite sturdy, and the latch holds well while in a pocket, however it may come undone if dropped (I will probably upload a redesign that can use a small cotter pin, or length of filament to hold it shut in the near future)
Statistics
Likes
0
Downloads
0