Raspberry Pi 3 (B/B+) Case Top with Raspberry Pi Logo

Raspberry Pi 3 (B/B+) Case Top with Raspberry Pi Logo

Description

It is basically the exact same case, but I wasn't a fan of the swirl design that was on top of the original case. So I decided to modify it to have the Raspberry Pi logo on the top, I thought it looked much cooler this way. In the .stl it shows some small overhang by the camera slot for some reason, but it wont actually try to print on your printer, so ignore it. I included the new top piece with the RPi logo, and the original bottom just so you know which bottom I used since there are so many in the original design. Printed the beginning 2 layers much slower(at about 50% speed = 30mm/s) as they would not stick to the print bed well at full speed since both parts have such small details. Print the first layers at 50% with the fan on and it should print just fine. I printed on a glass bed with no added adhesive(no glue stick/no masking tape).

Statistics

Likes

0

Downloads

1

Category

Electronics