LIGHT SABER INCENSE HOLDER
Description
CAUTION: Though I know the resin I used for this print is fire safe in the conditions I used it, NEVER assume any product you are using is. Always check the sds sheet before putting anything hot against a resin object. This print is made to hold incense sticks vertically down a canal through the statue. there is a smaller canal connecting to the battery box for wiring if you want to add an led to the top as I did int the picture. The three vent holes on the back of the center piece are necessary for air flow. Do not glue the bottom on. It is used to access the holder.
Statistics
Likes
0
Downloads
0