Shelf Legs
Description
I designed these base legs to use a shelf board I already had as a monitor riser. This will fit a board that is 16.25mm thick with some tolerance for a slightly thicker board. I used some thick double sided tape on the ends to fill in the slight gap, and prevent the brackets from sliding off. Raises the shelf board approximately 11cm/4.5". The alternate middle piece will work better for using with a monitor with a V style base. I printed this on my CR-6 Max but it should fit on most any printer, however smaller ones might need to orient it diagonally on the bed. No supports needed at all.
Statistics
Likes
0
Downloads
0