SSUPD Meshlicious HDMI Outlet Plate
Description
This is my version of a GPU plate that uses the hole in the back of an SSUPD Meshlicious ITX case. I made this after installing an ASRock Radeon RX 6900XT Formula OC, which is exactly 332mm long and therefore fits only in the lowest position. In this position, an HDMI 2.1 mount (made by ADT), which has a longer PCB for signal amplification/stabilization for 4k@120Hz, only fits at the very bottom of the plate and just clears the lower aluminum bar which the GPU sits on. In my case (pun intended) I only needed HDMI, so I didn't bother finding a way to fit a similarly sized DisplayPort also. The holes for the HDMI connector are 4.5mm and fit the respective M4 screws the connector needs. The other holes were made to fit some screws random case screws I had laying around: 3.5mm on the inner plate and 3.7mm on the outer plate, meant to be screwed together from the outside. (I think I will make an updated version that uses fan screws as they are more commonly available, but it doesn't have priority at the moment, so no ETA here.) The inner plate has a ridge that fits the hole and exceeds with its outer edge just enough to make it stable when screwed together. With a heated bed and a temperature set a little too high the inner plate can be printed so it snaps in place, but that was not my intention...
Statistics
Likes
0
Downloads
0