Kamen Rider OOO Medal Rim Remix
Description
This is a remix of the Core Medal Rim model from <a href="https://www.thingiverse.com/thing:4733920">here</a>. In the original version, you need to print two of the core medal rims and glue them together to put the fronts and backs in, but I wanted a version where the rim was a single piece that you could snap the fronts and backs into. So here it is! My medal rim remix is sized to fit most of the medal <i>fronts</i> in the link above as they are. The medal </i>backs are smaller, and should be sized up 200% on the X and Y, but NOT Z. (I think some of the bird medals are also the same size as the backs and should be sized up to 200%.) I also found in my printing that to ensure friction fit, the fronts of the medals may need to be sized up to 100.5% or 101% on the X and Y. (TLDR, the X and Y for the core medals and backs should be around 36.5mm in your slicer for a proper friction fit. If they come out a touch too small for the rim, you can glue them together without much issue.) I am not sure if there is still enough clearance to install rfid's and use these with the scanner, so if that's something you're concerned with, experimentation may be needed.
Statistics
Likes
0
Downloads
0