eSUN eBOX filament storage box front port plug
Description
Standard front outlet port did not quite fit my side-by-side setup and I decided to make a mod to run the filament from the back. The stl itself is of a plug to cover the front port after moving the outlet to the back. About the mod (how I did it): 1. push out the rod holding the case and the lid together 2. mark the cut out on paper tape 3. drilled several 4.8mm holes and filed the sides to be flat 4. filed some of the hinge side to put in the default connector in place The plug was printed after the mod, so wirks fine :) The plug can be printed with some TPU, but I did with PLA and seems to work fine, though a bit on the tight side. PS: The hygrometer mount can be found [here](https://www.thingiverse.com/thing:3935234).
Statistics
Likes
0
Downloads
1