Faceplate for Anycubic Mega S
Description
General ======= This isn't just a remix, I used the original design only to get correct dimensions. Publishing five distinct versions of this faceplate. You can use pause at height to change the filament colour for each layer type. **Version 1** --------- The first one, which is the most complex, has a base full layer (1mm in height), an hexagonal patter layer (1mm in height) and the "Anycubic" logo or left side and "Mega S" logo on right side that exceed previous layer by 1mm in height. **Version 2** --------- The second version could be more complicated to print and requires more attention because it only has the hexagonal area and logos. **Version 3** --------- The third version only has the full base layer (1mm) and the logo (1mm). **Version 4** --------- The fourth version has the full layer and the hexagonal pattern layer but does not have any logos. **Version 5** --------- The fifth version only has a hexagonal pattern layer. Notice ====== For the last two versions only one file is provided, you'll have to flip it using your slicer.
Statistics
Likes
0
Downloads
0