Vive Controller Mount for LucidVR Gloves - Modified
Description
I printed of the original and found the clamping pressure a little lack and the mount was far too thick. On the bottom part the slider rails are 2.5mm, the gap it fits into is only 1.70mm to 2.20mm wide, along with this I gave it similar geometry on the bottom as the LucidVR pot sliders. The top part where the controller sits I took off 1mm to get better clamping force. On the screw part I shorten by 1.5mm to compensate for the change. I also remove the text to simplify the print.
Statistics
Likes
0
Downloads
0