Robot Arm Holder
Description
This is an articulating robot arm. The slider clicks into several positions to hold the claws open or closed. This needs printed at 0.2mm layer height with 100% infill. If you have issues with the model, try slicing it in Cura! You will need to print two Claws. One will need to be mirrored/flipped. First, put the Slider into the arm with the eyelets on the Slider closer to the wrist of the arm. After that, put the Claws in place on the Wrist part. Attach the Rods to the Claws first, then attach them to the Slider. You can use a soldering iron or pliers to compress the rod ends so it doesn't come off. After that, the Upper Arm should snap into place.
Statistics
Likes
0
Downloads
0