M3D Filament Guide
Description
Update: Checkout This Thing... You Can Print 3 Out At Once. Http://Www.Thingiverse.Com/Thing:865138 This Is A Remix Of Http://Thingiverse.Com/Thing:746048. I Made The Clip Twice As Thick (Total Of 6Mm) And I Closed Up The Gap A Bit More So It Holds Onto The M3D Cable Better. I Left The Filament Hole The Same. The Pictures Above Are 6Mm Thick, But I Didn'T Tighten Up The Clamp Part On Those. It Is Tough To Notice In A Picture Anyway, But It Does Help With The Clamp Pulling Off The Cable.
Statistics
Likes
85
Downloads
0