The Tower - Enclosure for SKR 1.4 / PSU (Creality Upgrade)
Description
For Noise reduction i decided to upgrade my Creality CR-10s to a SKR 1.4 Board, TMC 2209 Driver and go with the stock PSU. However the stock Display didn't work out with the SKR board, so i had to change it with a BIGTREETECH TFT35 MZ V3.0 Display. After installation and few configurations everything was working fine but the stock PSU fan was also very loud and the stock enclosure didn't fit anymore. So i decided to build one. Here is "The Tower"! What you need: 2x 120mm FANS 1x SKR 1.4 Board 1x BTT TFT35 MZ V3.0 Display 1x MeanWell PSU 12x M3 screws You have to take out the stock PSU Enclosure with the FAN inside. Also the screws for the 120mm fans will be a little bit tricky but you can do it. This Setup is super quiet now. Have fun with it.
Statistics
Likes
1
Downloads
1