Logitech C270 Creality Enclosure Mount
Description
This is a C270 mount designed to be attached at one of the tube frames of a creality printer enclosure. But it can be used anywhere else. Two zip-ties are used to attach the mount to the tube on the enclosure. The max tube diameter the mount can be attached to is 16mm, anything below that will also fit. Anything above, with a little sanding will also fit. Using zip-ties you can attach this to anything you want. Infill - I suggest nothing below 15%. Most of it is going to be at the shaft itself. Orientation - I suggest following how it is orientated on the picture provided. Uses the least amount of supports. Supports - Depending on your settings, I would not support the zip-tie holes, they will be a pain to take out. Camera Focus Gear - https://www.thingiverse.com/thing:5861617
Statistics
Likes
0
Downloads
0