Clover Top
Description
This top is more open than any of my other designs, so it creates looks really amazing as it spins. It doesn't spin quite as long as some of the others (because it weighs less), but it's really stable (because most of the weight it has is in that center ring). I've included my STL files, PrusaSlicer 3MF file, and GCODE. The top is available as 1 piece and two. I recommend the 2 piece. It prints a lot smoother and takes less time (almost ½ the time of the 1 piece). They spin about the same. To assemble the top, just sand the flat art of each top a little to reduce the seam and add texture for the glue, then glue together with medium CA. If you want to print the 1 piece top, I'd suggest doing it inverted with the provided support collar. It goes around the stem and keeps the top from wobbling while it prints. The collar breaks away easily once the print is done if you get it adjusted right for your printer. I tried this technique with another of my tops and it worked OK, but the final print quality was pretty rough on top and it didn't spin better. It also took a lot longer and required more filament. Still, if you want to print the top as one piece, I recommend using the stem and printing just the first 30mm (takes about 45 minutes). While the print is still on the plate, try moving the stem sideways to see if it has give. Then, remove it from the plate and the collar and see if it was too tight. Then, scale the collar up or down as needed (probably no more than 0.5 - 1%). This is a great design for 2 or 3 color filament, rainbow filament, or adding color changes by swapping filament.
Statistics
Likes
0
Downloads
0