Anycubic i3 mega x (Phaetus dragon uhf + bmg lgx) Direct drive
Description
Installation ==================== Step 1: Insert brass inserts (M3 5.7x5.0) then insert M2.5 4.0x4.6 brass insert(optional used for adxl345. The m2.5 screws are only included in the fanduct) Step2: screw the hotend mount with phaetus dragon use the screws that were included in your hotend package step 2.5: add m3 nuts to the top of the carrier plate Step 3: Push your bmg lgx extruder to the hotend mount after that. screw it down from the back of the carrier plate with m3 30mm screws. Step 4: screw the holder mounts to the sites of the extruder use m3 12mm screws Step 5: remove the top wheels from your metal plate Step 6: use m3 16mm screws and screw the carrier plate from the back and mount it to the RearMount and fanduct from https://www.thingiverse.com/thing:4555831/files Step 6.5: mount your wheels back there should be enough space for a small wrench to tighten them back Step 7: pre crimp and extend your necessary stepper cables and plug those cables to the pancake stepper Step 7.5 Plug your hotend heater, nozzle fan and thermistor to the anycubic i3 mega x pcb Step 8 take your cover plate and screw 3010!!!(use m3 12mm) fan to it also screw the bltouch mount to the cover plate first then screw the bltouch to it!(for those wondering 4010 fans caused heat creep for some reason)(If you don't use custom z endstop solution bltouch will be necessary) Step 9: plug your hotend fan and bltouch to the pcb Step 10: You are done congratulation Firmware(Klipper settings) ==================== coming soon Recommendations ==================== https://www.thingiverse.com/thing:2555689 (Spool Holder) https://www.thingiverse.com/thing:4711013 (Spool holder no screws)
Statistics
Likes
0
Downloads
0