Work light for Einhell POWER X-Change battery
Description
I used battery adapter from @Hans_193091 (https://www.printables.com/model/243613-battery-adapter-einhell-power-x-change-general-pur) and updated design to work with frame of the work light. There are left and right side of the frame so wiring is easier. Both sides are held together by the bolt that holds light itself in the place, handle and some notches that stick into updated adapter. No gluing was needed, exept for 2 ring cable shoes on the bottom, so they stay positioned well enough. There is enough of room inside the frame so wires can go from worklight to ON/OFF switch and then to the adapter. Used materials: - Round ON/OFF rocker switch - 9-32V 48W LED work light - 2 ring cable shoes - Wires - Hot glue Supports are needed with left and right side, for handle and adapter no supports are needed (printing orientation shown on picture). Step files are attached.
Statistics
Likes
0
Downloads
1