Packout Airtag Mount v2
Description
I was never overly happy with my original Airtag holder for my Packout Rolling Toolbox (https://www.thingiverse.com/thing:5020376) so I finally decided to make a nicer version. The original was purely a friction fit but this one utilizes the 2 screw holes that are already in the lid for a cleaner look. It goes in the same location in the centre of the bottom row of the lid. This version should also use a little less filament than my original design. They AirTag holds nicely in the mount with friction and there is a small groove so that you can pry it out when battery changes are required. I used PETG as I always prefer stronger prints for toolbox things but PLA should be perfectly fine as well.
Statistics
Likes
0
Downloads
0