Corner Part Cooling Nozzle for 30mm Blower Fan
Description
This is one of many nozzles I came up with to leave a line of sight to evaluate hot end nozzle, and allow room to remove globs PRN while printing, or when hot block is too close to mount fan nozzle perpendicular to it. It solves that issue. It seems like I am losing a bit of air velocity with this design. the Testo numbers looked ok and been using with PETG with good results. Nozzles are my weakest area, feel free to improve on it. uses two screw 2mmx5 and 2mmx8. Then I mount it to any of the sides of the V6 quad fan mount.
Statistics
Likes
0
Downloads
1