Magnetic Headphone Holder
Description
This is the first draft of a simple headphone holder with a magnetic base. It still needs some work done to it. You'll need to include a pause in the print to place the magnets. The pause should be right before the layer that goes on top of the magnets, otherwise your nozzle will run into the magnets. I will also note that the hardened steel nozzle may cause problems when printing, as the magnets stick to it. I used the standard hot end that came with my Bambu P1P and this worked fine. The magnets I used for this are 8mm * 3mm, and I purchased them here: https://a.co/d/bbQZetM
Statistics
Likes
0
Downloads
0