Picture Frame Table Stand
Description
Needed a quick stand for some old wooden wall frames to be placed on tables. Also had some table frames with missing back supports so I threw this design together. I didn't have time to test out options so I am sure that the back support could be simplified quite a bit. I will look at altering the angle support to make it simpler and quicker to print if I get time. It uses a small back plate that is glued onto the back cardboard of the frame. The angled support can then be slid onto the frame. The support piece has 2 angles, so choose the best and position the clip for gluing. My pictures were around 200mm x 150mm but I suppose you can scale the part for other sizes if needed. I opted for this type of design so the holder would not be visible from the front.
Statistics
Likes
0
Downloads
0