Ender3 pro Adjustment wheel for 42-40 step motor upgrade
Description
I have upgrade my Ender 3 pro to run with a Double extruder and four extruding motors and a Duet Board. The x and y axis have been running hot since the conversion. I installed heat sink on both of the original 42-34 step motors. The x was still running around 48c and the y around 42. I was able to change the x axis without any issue to a 42-40, it runs at 34c now. The y axis required the use of a smaller wheel to allow for the complete motion of the carriage with the installation of the 42-40 stepper motor. I have include the file for the 47 mm wheel plus the y limit switch support bracket to adjust the position of the bed
Statistics
Likes
0
Downloads
0