Settlers of Catan 3 slot card holder_ anti slip
Description
Tired of all those Catan cards flailing around all over the place because of that "one" player? Well I have the solution for you. Designed to fit the Ender 3 base during printing the Settlers of Catan card holder is designed to fit all resource (brick, lumber, grain, wool, and development) cards divided in half. Print 2 of these babies and orient them on your printer flat or turned up where the back end is on the printer bed. Slap some anti slip rubber/tape on the bottom and put one on ether side of the playing board. Enjoy :) p.s. use your slicer to stretch this if you have the player expansion kit.
Statistics
Likes
0
Downloads
0