Pixel 7a - RE-LOAD -Qi Align helper
Description
Since the Qi Coil of the Pixel 7a is rather small and the Qi-Charging Speed isnt really fast (phone is limited to max 7,5W) the Alignment of the Phone on the QI Charger is critical. If the Phone is slightly Offset, the Charging speed will decrease. So i Designed a Simple Alignment Helper Tool. !! Attention: Only Tested with the RE-LOAD Wireless Charging Pad (Art-No.: 3011963 / Item-No.: 75.018.46 / 22CL05) But i think it will work with every Charging Pad, as long as it is 100mm in Diameter. There are two Versions: -Align helper Qi-v2.stl This is the Normal One, just for Aligning. -Align helper Qi-v2-Active.stl Since Cooling the Device while Charging can enable the Device to charge with higher Ampere for longer, i decided to adapt the Modular Fanholder from my other Charging Cooler found here: https://www.thingiverse.com/thing:6058080 If you decide to print the Cooling Version, you´ll need supports for the Press-Fit connector, since it will Overhang. i Printed them Upside Down, worked flawless. I taped the Charger and the Holder to the Table with Double-Sided Tape
Statistics
Likes
0
Downloads
0