AVR Dragon Case
Description
A case for the good old AVR Dragon programmer/debugger. I have completely redrawn this after a failed approach to remix [Farin's AVR Dragon Enclosure](https://www.thingiverse.com/thing:2979167). The original design was done as a sheet-cut by Brian Dory ([Blog Entry](https://www.briandorey.com/post/atmel-avr-dragon-programmer-case)). However, since things were cut out of flat sheets, there were some issues that could be fixed in the 3d world: - The original design had no feet, thus bottom screws/nuts scratched over the table. - There was quite some play (around 2 mm) for the board to tilt and rattle inside the box. The new design now has PCB holders that fit to the holes of the dragon board and some gap fillers. - The cutout was for using all debug interfaces, including the IC swap sockets (which probably wouldn't fit anyways, not sure). I reduced the cut out to the necessary (for me). If you need a top sheet with complete cut out, you can drop me a comment here. You can use M2.5 or maybe M3 screws, depending on printer accuracy. I used 12x M2.5 x 4mm screws.
Statistics
Likes
0
Downloads
0