HVAC vent mount 6 inches
Description
This model size is fine tuned to maximize print bed size of the Photon Mono X The model footprint is a square of 192mm x 192mm split in half (96mm) Each side would take 1h 55m to print ( Total of 3 hours ) Minimal support is needed on the screw part of the Vent Hole. The model has been made to be printed on the bed directly. Hand place a few support poles on the screw part inside the tube. **Warning** _The use of automatic support is **NOT** recommended and cause fitting issues._ _If you didn't fine tune your printer the elephant foot effect could cause tolerance issues._ **Enjoy !**
Statistics
Likes
0
Downloads
0