Dragy Suction Mount
Description
Since it´s not always possible to mount your dragy an a magnetic surface and I was not willing to buy an overpriced printed mount from the internet I thought I give it a go and design my own suction cup mount. It´s probably not perfect, but it works pretty well and doesn´t look too shabby. Due to it´s design, it´s possible to print it in PLA (but if you have PETG I would go with that). I used some threaded heat set inserts in M4x4.0x6.3 (but any M4 will do) and "massaged" them gently in the mount with a hammer. :) Then, all you need is two suction cups with an M4 screw and you are good to go. I tried printing the mount the way it comes and upside down and couldn´t decide which way I like best. So it´s up to you, which side you wanna look at when it´s stuck to your windshield.
Statistics
Likes
0
Downloads
0