Dual Fan Duct for Ender 5 (5, Pro, Plus)
Description
Works fine in PLA and PETG. It is designed to have enough clearance to allow to use the entire Y axis (not hit the frame). The hotend cooling fan adaptor makes it easy to acces the hotend. You can just pull it out and pull it back in. Proceed to hotend PID setting after installing the new hotend cooling fan. Use M3 screws. Pre-insert each screws to make a thread in the plastic then assemble. Attn: Don't tight up the screws too much. Use an M3 bolt to attach the right side of the shroud to the plate. A nut and washer go at the back of the plate. Attn: Use a crew that is not too long otherwise it will touch the frame. Design inspired by the original Satsana: https://www.thingiverse.com/thing:4528533
Statistics
Likes
0
Downloads
0