ATAT Kit Card - Fully Articulated - Scaled up to 150%
Description
I had a lot of trouble getting this to print in the card format from the original file, so I scaled the whole thing up to 150% and cut the file up into groups of parts. I had a lot of success doing it that way. In the picture for this Thing, all of the groups are different colors to show how I separated them. Also, I redesigned the lower leg part that the C clip goes into. I thought that it would look better if it was a mirror image. (part is in the lower left corner of the image with all of the parts). I think the STL file is just 1 part of the V2 lower leg, so make sure you duplicate it in the slicer program you use, as you'll need 4 of them total. I highly recommend printing the V2 part with supports. It was a bit of a pain printing each file one by one, BUT you could probably add a few parts at once in your slicer. I just had to print the "hoofs" separate as they would not print for me in the card. So I figured Id separate all of the other parts, too.
Statistics
Likes
1
Downloads
31