F16 Sim Landing gear Panel + Mounting
Description
This is the first 3D printed panel that I made for my F16 Flight sim. It uses some small switches with a diameter of 6 mm, for the lettering I went over them with a white marker after the print to make it more readable. For the small switches is printed some switch caps to make some bigger and some smaller, and also 1 for the hook and 1 for the landing lighting switch. I used the landing gear design by antares190 (https://www.thingiverse.com/thing:5377313). But only used 1 Locking switch without the springs, so now it only locks when the gear is up. For mounting I used a lot of small pins and holes so that I can still remove them if I need to change something. As for inputs I used an 8AI-36DI board from TLN Elettronica and the lights are controlled by an Arduino Nano. If you have any questions about the design or code just send a message, all try to respond ASAP
Statistics
Likes
0
Downloads
0