30L (brewing) bucket tipper
Description
<h1>Brewing bucket tipper</h1> </p> <p>Simple block to tip a 30-liter plastic bucket to a 30-degree angle. </p> <p>I use it to drain the brewing bucket (with a draining tube) without stirring the sediment at the bottom.</p> <p>The bucket I used for design has a 320mm bottom diameter and 4,6° side angle.</p> </p> <p>I used 7% infill; probably could go down to 5% (haven't tested!). More than that is just a waste of filament.</p>
Statistics
Likes
0
Downloads
0