Low Voltage Worklight
Description
This Two Part Print Will Hold And Protect A Standard Mr16 Low Voltage Led Downlight. Note: Do Not Use It With A Halogen Bulb... It Will Melt. I Used It As A Worklight On My Colchester Lathe. I Purchased Cheap Led Clamp On Type Reading Light From A Well Known Hardware Store But The Cob Chip In The Head Of The Lamp Failed After Just A Few Hours Use And Since I Had Modified The Flexible Stem And Switch I Couldn'T Return It. I Tried And Failed To Find A Suitable Replacement For The Led Chip And Decided That Standard Downlight Bulbs Were Easier To Replace In The Future. The End Of The Housing Has A 12Mm Diameter Socket For Fitting Over The Flexible Gooseneck But You Can Modify The Inventor Source File To Suit What You Have. I Have Also Included A Two Part Print Which Allows For A Rocker Switch To Be Fitted Directly To The Stem Of The Flexible Gooseneck. I Found A Rocker Switch In My Scrap Box Which Was About The Right Size So The Print Was Modelled Specifically For That Switch. I Have Included The Original Inventor Parts So You May Be Able To Edit The Parts To Suit A Switch That You Might Have.
Statistics
Likes
83
Downloads
0