Anycubic Vyper direct drive 2023
Description
Fits the newest version of the Anycubic Vyper ( i bought mine in April 2023). Might make the vyper a bit slower (50 mm/s with Linear Advance at 0.2K value) but no more stringing and TPU prints better then some printers do PLA. When you install the extruder you need a 50cm long 4 to 6 pin cable and switch the two pins on the outsides of the 4 pin connector. Also i had to take out the black clip for the bowden tube thats between the extruder and hotend because the calibartion was not working how it should. Thx to Ivan Lisi for the Files i used to make this version :).
Statistics
Likes
0
Downloads
1