Stratux T-Shaped Case
Description
Stratux case with modular components to accommodate Raspberry Pi4 and Pi3 boards One could just print the Main Body and the Case Cover (Choose One-Piece or Three-Piece) and call it good. The other components are optional enhancements. I printed the Case Covers in PETG for extra strength + heat resistance as the PLA covers would warp over time. GPS Half Shields - If you have the MPU9250 AHRS module (https://www.ebay.com/itm/166104597818), print the Left_wAHRS_Shelf one The Case Cover Three-Piece option was to be able to more easily access the GPS module that I occasionally had to reseat. Only two screws instead of six. Special Thanks to mistertech at https://www.thingiverse.com/thing:1707442 for some of the initial inspiration for this design. Optional "Battery Pylons" are shaped for the following batteries: INIU 20000mAh USB C Power Bank: https://www.amazon.com/gp/product/B07YPY31FL INIU 10000mAh USB C Power Bank [2 Pack]: https://www.amazon.com/gp/product/B08MBQS368 If you have a different battery, it should be easy to design up ones to fit. USB C Cable 1FT https://www.amazon.com/gp/product/B0B4DL85GQ Optional: Removable 1.8 Inch Clear Suction Cups: https://www.amazon.com/gp/product/B08ZS7MV1K
Statistics
Likes
0
Downloads
0