Cable Organizer/ Holder Collection

Description

Heyho Here you have a collection of Holder to tame your Cable jumble :D I got inspired by different Solutions like peaberry´s Cable Tie Base. I Printed mine with ASA, 0,2 mm layer Height, 0,6 mm Nozzle, 100% infill, 2-3 Perimeter. Holder Selection: Single, I, T, + Holder (3 mm Screw) Width for the cable tie: 4,8 mm Pyramid + Screw (S = 3 mm, M = 3,5 mm, L = 4 mm) Width for the cable: S = 4,15 mm M =4,84 mm L = 5,3 mm Pyramid + Double Sided Tape (Fast & Cheap print, less strength) Width for the cable: S = 3,48 mm M = 4 mm L = 5,2 mm I tested all Pyramid (S) and normal Versions to compare its strength. No wonder: The screwed ones are far stronger. Only the Pyramid (s) got destroyed during the test with a crowbar :) With all other models or if layed through 2 loops of the pyramid, the holder survived the test and instead the cable ties broke. The holder got only a small visible deformation after the cable ties broke. Installation tipps: a) You can use the holder in different ways. Eather to crowd 4 cable ties into the pyramid or Plus Holder or use 1-2 Cables and increase the strength of the holder this way. b) You can scale the holder up/ down if you need special sizes. c) Do not overtighten the screws. I used a torque around 5 Nm and it worked just fine. Have fun and keep printin! :)

Statistics

Category

Tags