Retainer for axle nut of a MRP fork
Description
The nut at the axle of a MRP Ribbon fork spins as you screw in the axle. This is annoying as you have to find the correct position of the nut to have the axle lever in the desired position. This retainer fits over the nut and keeps the nut from spinning. To use it, screw in your axle and set the lever to the right position. Then put the retainer over the nut, aligned so that the nose fits in the small cutout of the fork. You may have to correct the position of the nut a bit, because the nose can only fit in one of 12 positions. The ring at the retainer should be located at the outside. It helps to remove the retainer. I made it for my MRP Ribbon, but may work for other MRP forks as well. Please let me know if you verify this with other forks. I printed that in PETG with a 0.3mm nozzle and 0.25mm layer height on my Prusa mini.
Statistics
Likes
0
Downloads
0