Valve Tool For Inflatables - 8 Notch - SUP - RAFT - KAYAK
Description
I needed a tool to adjust or remove an 8 slot valve from my Stand Up Paddle Board. I found 6 notch versions on thingiverse, but nothing for an 8 slot valve. I pulled out the caliper, FreeCad and made this. It works great for me. I printed in PETG but I'm sure PLA would be fine. Just print with a greater infill (~30% for me) and an infill with good horizontal strength, I used tri-hexigon in Cura. I think I printed with .16 layers, but .20 would probably be good enough.
Statistics
Likes
0
Downloads
1