Skateboard Handle(Meepo Mini2S)
Description
Hi Guys, Every day I have to walk with my board through a large train station, so I created this helpful handle I made for my Mini2S. I suspect it might fit other boards, but haven't been able to test that. Here is the link if you want to use the CAD: https://cad.onshape.com/documents/1acbee5e3e6a5cd9478418f0/v/9458b95d4a7917d7112bb266/e/98bb2ca69430d585c00f3e98?renderMode=0&uiState=64e0e9d6dd28b44be959fcab PRINTING: I used 3 Walls and 100% Infill BOM: -3D Printed Handle -10-32 Heat Set Inserts https://www.mcmaster.com/93365A154/ -1" 10-32 Bolts https://www.mcmaster.com/90128A947/(Or hardware store) INSTALLATION INSTRUCTIONS: 1. Use a soldering iron to sink 3 heat-set inserts into the handle 2. Shimmy the handle onto the board where you want it. 3. Use your drill bit to mark the 3 hole locations. 4. Take the handle off(so we can avoid drilling into the inserts) 5. Drill the 3 holes in the marked locations 6. Put the handle back on and tighten the 10-32, 1" length bolts I have tested this without issue for about 5 months. Let me know if you make this!
Statistics
Likes
0
Downloads
0