Wolverine MTW Feeding Tube (Billet pre Oct 2021)
Description
Built from scratch in TinkerCAD, so it may not be the most polished model. Have tested with Wolverine and PTS mags, no feed issues on my set up. Depending on your printer/print settings the feed tube may be tight for bbs to pass through if there's a "seam" inside the tube. I found a bit of sand paper wrapped around a cleaning rod resolved this (and then cleaning grit out afterwards). Tube is deliberately snug to reduce air loss past following bbs (i don't know if it actually makes a difference though)
Statistics
Likes
0
Downloads
0