Duplicator I3 Controlbox Cover for LCD v2.0
Description
The Second Attempt At Modding A Front Angled Cover For The Duplicator I3'S Control Box. This Time, I Added : - 40Mm Fan On The Bottom Side (Would Work Best If Back Cover Uses A Fan Extracting Air Too) Recommended Screws Would Be 4 X M3X15. - Front Button For Emergency Stopping And Better Gap Between The Original Wheel And The Print.(No Springs Or Anything Required) The One In The Pictures Follows This Config : Pla @195°C, 0.3 Layers With 30% Infill And 50Mm/S Speed (+ Activate Support) And It Was Done Using My Fresh Duplicator I3 In About 7.5 Hours. Https://Youtu.Be/Swb5Zudnt1Y Don'T Forget To Activate Support Unless The Lcd Window Is Never Gonna Print Correclty !!
Statistics
Likes
76
Downloads
0