Filament runout switch and Bowden tube fitting for 2020 extrusion mounting
Description
I wanted an easier way to feed filament into my Voron 2.4 from a dryer box sitting beside the printer. This bracket holds a microswitch (wired to an otherwise-unused endstop switch input) and the printer.cfg contains the following: [filament_switch_sensor Filament] pause_on_runout: TRUE runout_gcode: M600 event_delay: 300 #Five minutes of printing after sensor is triggered pause_delay: 0.5 switch_pin: PG11 Note that PG11 might not be the right pin for your board, I'm using the Octopus board that came with a Formbot kit. Search for your board name and the word 'pinout' to find the pin names
Statistics
Likes
0
Downloads
0