'97 Diahatsu Hijet S110P Dash Phone Mount
Description
I created this phone mount base for a phone mount that I bought, since the original clamp mechanism didn't clip on my dash properly. This base is made to fit into the rightmost dash bolt hole. Just remove the cover and the M6 screw. Disassemble the dash clip and screw down to the top of the 3d print. Install the base and the top assembly, secure with a M6x30mm button head screw. I split the model into two pieces since I didn't have good supports on PC or ABS. These parts can be printed without supports (a brim may be needed). Make sure to print with a high temp material to keep the parts from warping in the sun. This is the phone mount that I bought originally, it is reasonable quality and is fairly cheap. I want to design a better mount but this works for now. amazon.com/dp/B0C2NFY5Y5
Statistics
Likes
0
Downloads
0