Kona 2020 frunk mounts with integrated grommets
Description
These are the models for the frunk mounts with integrated grommets. The preferred material is probably some variation of TPU. I used Superslicer to slice these models and printed them with manually drawn supports of about 3 mm with approximately 2 mm spaces for the aluminum bar slot. The spacing has to be wide enough to slide in a pair of pliers and remove the support material. I'm not sure if the height of the parts is correct and I haven't actually installed them on my Kona. I will update this later with the results or adjustments.
Statistics
Likes
0
Downloads
0