Shimano I-Spec B bar clamp

Shimano I-Spec B bar clamp

Description

I bought some shifters which use the I-Spec B mounting interface, but I don't have the accompanying brakes. * therefore, I made my own clamp * rev 3 & 4 both leverage cast aluminum fittings that bridge between the shifter & the bar that came with my shifters * M5 bolts & nuts required * rev 3 has the shifter bolt coaxial with the bar clamp bolt, which puts the shifter vertically too far down for ease of each -- hence, rev 4 where it's the shifter mounting bolt axis is 4.5 mm below the bar axis * printed in PLA just fine * printed in Clear resin on Form 3, seems fine so far though I thought it might be too brittle

Statistics

Likes

0

Downloads

0