Noctua 92mm fan reassembly bracket
Description
This is made for my rtx 3060 shroud project (https://www.thingiverse.com/thing:6191357), where the fan is cut down to only the central part. If you chose to make the shroud, with this the fan will not be totally unuseable for the future. The fan is slid into from the side, in which it will stay in place and nothing else will need to be done. Only reajust a tiny bit if it is not quite in the middle of the frame. The cable is routed under the cable guide and to the hole where it won't hinder the fan and the bracket is then screwed into the frame from the bottom. This will add 2,5mm of thickness. If it is an intake or outtake fan in a case, this can be printed in PLA. If it is meant to go on a gpu/cpu cooler or very close to a hot component, a heat resistant filament like PETG or ASA is recommended.
Statistics
Likes
0
Downloads
0