Customizable Blowgun Mouthpiece
Description
A customizable mouthpiece for a blowgun. The piece consists of two segments: the holding part, 30mm long, that will clamp on the blowgun. And the weight part, length and diameters customizable. For the weight you can set a different diameter on the bottom. The reason is that I find it easier to see a defined edge while aiming. So I designed the lower part slightly smaller for my version so I am unable to see the barrel of the weight. Just try it out for yourself. There are two version as STL that fit the Coldsteel Big Bore Pro (22mm outer and 16mm inner diameter): - weight 20mm long with diameter of 36 mm - weight 20mm long with diameter from 36m to 33mm You need to hack in the following parameters: - Outer diameter of your blowgun - Inner diameter of the blowgun - Desired outer diameter of the weight at the upper point - Desired outer diameter of the weight at the lowest point - Length of the weight Printed with PLA+,100% fill and no support.
Statistics
Likes
0
Downloads
5