ITX case
Description
Every piece can be printed on a 220mmx220mm bed This is the fist thing I've designed so any feedback would be much appreciated GPU mounting needs to be glued, only done so things can be printed with minimal supports Feet are designed to be printed out of flexible plastic and pushed into the bottom panel it will require 2 of the feet to be mirrored in when sliced Fixings I used to screw everything together https://www.amazon.co.uk/dp/B075WY5367?psc=1&ref=ppx_yo2ov_dt_b_product_details The nuts may need a drop of glue to hold them in but can be fine without If I change anything it will be to fix where the front panel attaches to the bottom panel to make it the same as the top
Statistics
Likes
23
Downloads
20