9mm Snap Cap (With Firing Pin support)
Description
Print using 80% infill. No supports. The included GCODE was made for Prusa Mk. 3/4 It should work with Ender as well, it will print 5 at once. This version allows your firing pin/striker to just barely hit the primer cavity on the rear, so the firing pin or striker shuttle isn't just ramming into your metal slide as you dryfire. I also lengthened the tip .21 mm for better feeding as it seemed a hair too short. Tested in my Glock 19. Tested in UTG magazines, OEM magazines and printed magazines.
Statistics
Likes
9
Downloads
18