CTRE Pigeon 2.0 Mount
Description
This is a mount for the CTRE Pigeon 2.0 IMU. It mounts it to the two screw points on a RoboRIO. You will need two M3x12mm screws to mount the Pigeon to the print (though you may need to file down the heads of your screws so they can fit in the countersunk holes of the Pigeon) and two #4-40 1/4″ screws to hold the mount to the RoboRio. I'd recommend putting some VHB tape under the mount to reduce vibrations and hold the bottom snug to the RoboRIO.
Statistics
Likes
0
Downloads
0