Chastity Cage Locking Pin (using handcuff key)
Description
Inspired by the New Fun Chastity Cage Hinge Pin but built completely from scratch. The design is based on an unbranded cage purchased from Amazon. Use a standard handcuff key to rotate/lock it once in place. The dimensions (diameter x length) for the individual segments of the pin are as follows: - Cylinder+Taper: 6.28 x 18+4.5 - Dowel+Tip: 3.0 x 3.0+0.5 - Locking Tab: 3.0 x 6.0>5.25 (from centre of cylinder) - Key Way/Peg: 3.68/2.68 x 3.75 - Key Flag: 1.0 x 3.5 (from centre of Key-Way) The tolerances used for the handcuff key way are extremely tight to preserve as much material (and strength) around it. My Smith & Wesson key is an exact fit; it slides in with minimal resistance and lightly holds onto the pin. You may need to adjust the tolerances around your key and/or printer.
Statistics
Likes
0
Downloads
15