MGN9H Linear Rail Mount Sherpa V6 for Aquila (S2 and X2) and Ender 3
Description
09/13/2023 1400: I uploaded wrong mount files initially for whoever downloaded earlier. Correct version is up now. If someone could let me know if the Ender 3 mount works. Amazon had MGN9H 300mm linear rail on sale for 10$, typically 12mm rails are used, but using a sherpa and a V6 centered over the bearing will work. I built for Aquila printers, the x limit switch requires a extra 4mm protrusion compared to Ender . To compensate for the 16.5 mm offset by centering over the bearing, I extended the X plate, to keep the nozzle center for ender 3 , hopefully that works I dont have a ender , so I dont know where the limit switch is. You need to adjust z limit switch as change z height, attatched to 20-20 x axis extrusion with m3x8mm and t-nuts all the way down the linear rail four 8mm countersunk 3m for mount to bearing, Two M3 30mm or longer with nut for V6 mount print same V6 clamp for both two M3 25mm with nut for sherpa mount. I use my bowden to wade plug for the V6, and slim slide on dual fan heat sink design and one of my 45degreee (one screw mount part cooling nozzle) I printed with Priline super hard CF-PC. .5nozzle .25 layers 240C 60C bed 25mm/sec no fan
Statistics
Likes
0
Downloads
1